Data Signal Circuit between Navigation Receiver Assembly and Stereo Jack Adapter [09/2013 - ]: Procedure
- CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
- Disconnect the E136 navigation receiver assembly connector.
- Disconnect the E137 No. 1 stereo jack adapter assembly connector.
- Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection Condition Specified Condition E136-2 - E137-2 Always Below 1 Ω E136-3 - E137-3 Always Below 1 Ω E136-5 - E137-5 Always Below 1 Ω E136-2 - Body ground Always 10 kΩ or higher E136-3 - Body ground Always 10 kΩ or higher E136-5 - Body ground Always 10 kΩ or higher
NG → REPAIR OR REPLACE HARNESS OR CONNECTOR
OK → See step 2
- PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE. Refer to PROBLEM SYMPTOMS TABLE [09/2013 - ]