LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2014 >> RAV4 LE, AWD >> Repair and Diagnosis (Single Page) >> Body & Frame >> Windows >> Power Window Control System (W/ Jam Protection) - Diagnostics - Introduction - (Except Hybrid) >> POWER WINDOW CONTROL SYSTEM (W/ Jam Protection Function) >> Data List / Active Test [12/2012 - 10/2015] >> Data List / Active Test [12/2012 - 10/2015]
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Data List / Active Test [12/2012 - 10/2015]

  1. DATA LIST 

    HINT: 

    Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    NOTE:

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

    1. Connect the Techstream to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical / D-Door Motor or Main Body / Data List.
    5. Read the Data List according to the display on the Techstream.

      Body Electrical > D-Door Motor > Data List 

      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      D Door P/W Auto SW Driver door power window auto switch signal ON or OFF ON: Driver door power window auto switch being operated
      OFF: Driver door power window auto switch not being operated      		 -
      D Door P/W Up SW Driver door power window manual up switch signal ON or OFF ON: Driver door power window manual up switch being operated
      OFF: Driver door power window manual up switch not being operated      		 -
      D Door P/W Down SW Driver door power window manual down switch signal ON or OFF ON: Driver door power window manual down switch being operated
      OFF: Driver door power window manual down switch not being operated      		 -
      Glass Position (Close-1/4) Margin for jam protection triggering force of window glass within range of fully closed to 1/4 open window glass position OK or Caution OK: Normal manual up operation
      Caution: Jam detected in the specified range      		 Caution is displayed only while the power window ECU built into the power window regulator motor assembly detects a jam.
      Glass Position (1/4-2/4) Margin for jam protection triggering force of window glass within range of 1/4 to 1/2 open window glass position OK or Caution OK: Normal manual up operation
      Caution: Jam detected in the specified range      		 Caution is displayed only while the power window ECU built into the power window regulator motor assembly detects a jam.
      Glass Position (2/4-3/4) Margin for jam protection triggering force of window glass within range of 1/2 to 3/4 open window glass position OK or Caution OK: Normal manual up operation
      Caution: Jam detected in the specified range      		 Caution is displayed only while the power window ECU built into the power window regulator motor assembly detects a jam.
      Glass Position (3/4-Open) Margin for jam protection triggering force of window glass within range of 3/4 to fully open window glass position OK or Caution OK: Normal manual up operation
      Caution: Jam detected in the specified range      		 Caution is displayed only while the power window ECU built into the power window regulator motor assembly detects a jam.
      Number of Trouble Codes Number of trouble codes Min.: 0 or Max.: 255 Number of DTCs will be displayed -

      Body Electrical > Main Body > Data List 

      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      FR Door Courtesy SW Front door courtesy light switch RH ON or OFF ON: Front door RH open
      OFF: Front door RH closed      		 -
      FL Door Courtesy SW Front door courtesy light switch LH ON or OFF ON: Front door LH open
      OFF: Front door LH closed      		 -
      Communication D-Door Motor Connection status between front power window regulator motor assembly LH and main body ECU (multiplex network body ECU) OK or STOP OK: Normal communication
      STOP: Communication stopped      		 -
  2. ACTIVE TEST 

    HINT: 

    Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

    1. Connect the Techstream to the DLC3.
    2. Turn the ignition switch to ON.
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical / D-Door Motor or Main Body / Active Test.
    5. According to the display on the Techstream, perform the Active Test.
      WARNING:

      Be careful to avoid injuries as this test causes vehicle parts to move. During the Active Test, the jam protection function will not operate.

      Body Electrical > D-Door Motor > Active Test 

      Tester Display Measurement Item Control Range Diagnostic Note
      Power Window Driver door power window OFF, UP or DOWN -

      HINT: 

      Up and down movement does not occur if the arrow is not pressed and held.

      Body Electrical > Main Body > Active Test 

      Tester Display Measurement Item Control Range Diagnostic Note
      IG OFF P/W Control Permission Output Power window OFF or ON Perform this Active Test with the ignition switch off

      HINT: 

      If Active Test is turned on, only the driver side power window does not operate.

scientia non olet · About LEMON Manuals