Driver Side Power Window Auto Up / Down Function does not Operate with Power Window Master Switch [08/2013 - ]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Master switch / Data List.
5. Read the Data List according to the display on the Techstream.
   MASTER SWITCH (MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY)
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   D Door P/W Auto SW	Driver side power window auto up/down switch signal / ON or OFF	ON: Driver side power window auto switch operated OFF: Driver side power window auto switch not operated	-

   OK

   On the Techstream screen, ON or OFF is displayed accordingly.

NG → See step   7 

OK: Go to next step 

1. Enter the following menus: Body Electrical / D-Door Motor / Data List.
2. Read the Data List according to the display on the Techstream.
   D-DOOR MOTOR (FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH)
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   D Door P/W Auto SW	Driver side power window auto up/down switch signal / ON or OFF	ON: Driver side power window auto switch operated OFF: Driver side power window auto switch not operated	-

   OK

   On the Techstream screen, ON or OFF is displayed accordingly.

NG → See step   5 

OK: Go to next step 

1. Initialize the front power window regulator motor assembly LH. Refer to INITIALIZATION [08/2013 - ] .

NEXT: Go to next step 

1. Check that the driver side door power window moves when the auto up/down function of the multiplex network master switch assembly is operated. Refer to OPERATION CHECK [08/2013 - ] .

   OK

   Driver side auto up/down function is normal.

NG → See step   8 

OK → END (PROBLEM DUE TO INITIALIZATION FAILURE) 

1. Replace the multiplex network master switch assembly. Refer to REMOVAL [08/2013 - ] .

NEXT: Go to next step 

1. Check that the driver side door power window moves when the auto up/down function of the multiplex network master switch assembly is operated. Refer to OPERATION CHECK [08/2013 - ] .

   OK

   Driver side auto up/down function is normal.

NG → See step   8 

OK → END (MULTIPLEX NETWORK MASTER SWITCH WAS DEFECTIVE)