DTC P060D: Internal Control Module Accelerator Pedal Position Performance [08/2014 - ]: Procedure

CHECK FOR DTC
1. Clear DTCs. Refer to DTC CHECK / CLEAR [08/2014 - ] .
2. Turn the ignition switch off.
3. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
4. Connect the cable to the negative (-) battery terminal.
5. Turn the ignition switch to ON.
6. Check for DTCs.
  OK
  
  P060D is not output.
NG → See step 3

OK → See step 2
CHECK FOR INTERMITTENT PROBLEMS. Refer to CHECK FOR INTERMITTENT PROBLEMS [08/2014 - ]
REPLACE ECM. Refer to REMOVAL [08/2014 - ]