Mute Signal Circuit between Navigation Receiver Assembly and Stereo Component Amplifier [08/2014 - ]: Procedure

1. Measure the voltage according to the value(s) in the table below.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   N11-1 (MUTE) - Body ground	Ignition switch ACC, audio system playing → Changing modes	Above 3.5 V → Below 1 V

   TEXT IN ILLUSTRATION
   
   

   *a	Component with harness connected (Stereo Component Amplifier Assembly)

NG → See step   2 

OK → See step   5 

1. Disconnect the G37 navigation receiver assembly connector.
2. Disconnect the N11 stereo component amplifier assembly connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   G37-16 (MUT1) - N11-1 (MUTE)	Always	Below 1 Ω
   G37-16 (MUT1) - Body ground	Always	10 kΩ or higher

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: Go to next step 

1. Reconnect the N11 stereo component amplifier assembly connector.
2. Disconnect the G37 navigation receiver assembly connector.
3. Measure the voltage according to the value(s) in the table below.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   G37-16 (MUT1) - Body ground	Ignition switch ACC, audio system is playing	Above 3.5 V

   TEXT IN ILLUSTRATION
   
   

   *a	Front view of wire harness connector (to Navigation Receiver Assembly)

NG → See step   4 

OK → See step   6