Front Passenger Side Power Window Auto Up / Down Function does not Operate with Front Passenger Side Power Window Switch [09/2014 - ]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / P-Door Motor / Data List.
5. Read the Data List according to the display on the Techstream.
   P-DOOR MOTOR
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   P Door P/W Auto SW	Front Passenger door power window auto switch signal / OFF or ON	OFF: Front passenger door power window auto switch not being operated ON: Front passenger door power window auto switch being operated	-

   OK

   On the Techstream screen, ON or OFF is displayed accordingly.

NG → See step   4 

OK: Go to next step 

1. Initialize the power window regulator motor assembly (for front passenger door). Refer to INITIALIZATION [09/2014 - ] .

NEXT: Go to next step 

1. Check that the front passenger door power window moves when the auto up and down function of the power window regulator switch assembly is operated. Refer to OPERATION CHECK [09/2014 - ] .

   OK

   Front passenger door auto up and down function is normal.

NG → See step   6 

OK → END (PROBLEM DUE TO INITIALIZATION FAILURE) 

1. Remove the power window regulator switch assembly.. Refer to REMOVAL [09/2014 - ] .
2. Inspect the power window regulator switch assembly. Refer to INSPECTION [09/2014 - ] .

NG → See step   7 

OK: Go to next step 

1. Disconnect the J18 power window regulator motor assembly (for front passenger door) connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   J15-8 (AUTO) - J18-4 (AUTO)	Always	Below 1 Ω
   J15-8 (AUTO) or J18-4 (AUTO) - Body ground	Always	10 kΩ or higher

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK → See step   6