Jam Protection Function does not Operate [09/2014 - ]: Procedure

PERFORM INITIALIZATION (APPLICABLE LOCATION)
1. Initialize the power window regulator motor assembly (applicable location). Refer to INITIALIZATION [09/2014 - ] .
NEXT: Go to next step
CHECK POWER WINDOW CONTROL SYSTEM (AUTO UP / DOWN FUNCTION)
1. Check if the power window auto up and down function operates normally. Refer to OPERATION CHECK [09/2014 - ] .
  OK
  
  Auto up and down function is normal.
NG → See step 4

OK: Go to next step
CHECK JAM PROTECTION FUNCTION OPERATING RANGE
1. Check if the jam protection function operates normally for the applicable power window.
  HINT:
  
  The jam protection function will not operate within 4 mm (0.157 in.) of the fully closed position.
  
  OK
  
  Jam protection function operates normally.
NG → See step 5

OK → END (PROBLEM DUE TO INITIALIZATION FAILURE)
GO TO OTHER PROBLEM (Proceed to Problem Symptoms Table). Refer to PROBLEM SYMPTOMS TABLE [09/2014 - ]
REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY LH (FOR DRIVER DOOR OR FRONT PASSENGER DOOR). Refer to REMOVAL [09/2014 - ]