DTC P0705: Transmission Range Sensor Circuit Malfunction (PRNDL Input) [08/2013 - 08/2016]: Description

The park/neutral position switch assembly and transmission floor shift assembly (transmission control switch) detect the shift lever position and send signals to the ECM.

DTC No.	Detection Item	DTC Detection Condition	Trouble Area	MIL	Memory
P0705	Transmission Range Sensor Circuit Malfunction (PRNDL Input)	Diagnosis Condition The ignition switch is ON and battery voltage is 10.5 V or more. Malfunction Status 2 or more of the following signals are ON simultaneously. (NSW, P, N) input signal R input signal D input signal B input signal Malfunction Time 2 seconds Other 2-trip detection logic Diagnosis Condition The ignition switch is ON and battery voltage is 10.5 V or more. Malfunction Status All signals are OFF simultaneously. NSW input signal P input signal R input signal N input signal D input signal B input signal Malfunction Time 60 seconds Other 2-trip detection logic Diagnosis Condition The ignition switch is ON and battery voltage is 10.5 V or more. Malfunction Status Any of the following signals and the S (SDSW) or M signal are ON simultaneously. NSW input signal P input signal R input signal N input signal B input signal Malfunction Time 2 seconds Other 2-trip detection logic	Wire harness or connector Park/neutral position switch assembly Transmission floor shift assembly (Transmission control switch) ECM	Comes on	DTC stored

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

MIL

Memory

P0705

Transmission Range Sensor Circuit Malfunction (PRNDL Input)

Diagnosis Condition
- The ignition switch is ON and battery voltage is 10.5 V or more.
Malfunction Status
- 2 or more of the following signals are ON simultaneously.
  - (NSW, P, N) input signal
  - R input signal
  - D input signal
  - B input signal
Malfunction Time
- 2 seconds
Other
- 2-trip detection logic

Diagnosis Condition
- The ignition switch is ON and battery voltage is 10.5 V or more.
Malfunction Status
- All signals are OFF simultaneously.
  - NSW input signal
  - P input signal
  - R input signal
  - N input signal
  - D input signal
  - B input signal
Malfunction Time
- 60 seconds
Other
- 2-trip detection logic

Diagnosis Condition
- The ignition switch is ON and battery voltage is 10.5 V or more.
Malfunction Status
- Any of the following signals and the S (SDSW) or M signal are ON simultaneously.
  - NSW input signal
  - P input signal
  - R input signal
  - N input signal
  - B input signal
Malfunction Time
- 2 seconds
Other
- 2-trip detection logic

Wire harness or connector
Park/neutral position switch assembly
Transmission floor shift assembly (Transmission control switch)
ECM

Comes on

DTC stored