DTC P0D52-407: On-Board Charger Output Current Sensor Circuit Range / Performance [08/2014 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.

CHECK DTC OUTPUT (PLUG-IN CONTROL)

Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Enter the following menus: Powertrain / Plug-in Control / Trouble Codes.

Check if DTCs are output.

Result

Result	Proceed to
Only P0D52-407 is output or P0D52-407 and DTCs other than the ones in the table below are also output.	A
Any of the following DTCs are also output.	B

DTC No.	Relevant Diagnosis
P060B-134, 135, 570	Internal Control Module A/D Processing Performance
P0D53-408	On-Board Charger Output Current Sensor Circuit Low
P0D54-409	On-Board Charger Output Current Sensor Circuit High

HINT:

P0D52-407 may be output due to a malfunction which causes the DTCs in the table above to be output. In this case, first troubleshoot the output DTCs in the table above. Then, perform a reproduction test to check that no DTCs are output.

Turn the power switch off.

B → See step 3

A: Go to next step

CHECK ELECTRIC VEHICLE CHARGER ASSEMBLY (ICHG SENSOR OUTPUT VOLTAGE) See step   8
NG → See step   4

OK → See step   5
GO TO DTC CHART (PLUG-IN CHARGE CONTROL SYSTEM). Refer to DIAGNOSTIC TROUBLE CODE CHART [08/2014 - ]
REPLACE ELECTRIC VEHICLE CHARGER ASSEMBLY. Refer to COMPONENTS [08/2014 - ]
REPLACE PLUGIN CHARGE CONTROL ECU ASSEMBLY. Refer to COMPONENTS [08/2014 - ]