LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2015 >> Prius One >> Repair and Diagnosis (Single Page) >> External Pages >> Different variant/trim >> Section 115 (Brake Control System - (Service Information) (Plug-In)) >> Steering Angle Sensor >> Installation [08/2014 - ] >> Installation [08/2014 - ]
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation [08/2014 - ]

WARNING: This page is about a different variant/trim than selected.
  1. INSTALL SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY 
    1. Install the spiral cable with sensor sub-assembly. Refer to INSTALLATION [08/2014 - ] - Step 1 .
      NOTE:
      • Do not replace the spiral cable with sensor sub-assembly with the auxiliary battery connected and the power switch on (IG).
      • Do not rotate the spiral cable with sensor sub-assembly with the auxiliary battery connected and the power switch on (IG).
      • Ensure that the steering wheel is installed and aligned straight when inspecting the steering angle sensor.
      • Do not remove the steering angle sensor from the spiral cable.
  2. INSTALL UPPER STEERING COLUMN COVER  . Refer to INSTALLATION [08/2014 - ] - Step 12
  3. INSTALL LOWER STEERING COLUMN COVER  . Refer to INSTALLATION [08/2014 - ] - Step 13
  4. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD 
  5. ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY  . Refer to INSTALLATION [08/2014 - ] - Step 5
  6. INSTALL STEERING WHEEL ASSEMBLY 

    Refer to INSTALLATION [08/2014 - ] - Step 8

scientia non olet · About LEMON Manuals