DTC P0D53-408: On-Board Charger Output Current Sensor Circuit Low; DTC P0D54-409: On-Board Charger Output Current Sensor Circuit High [08/2014 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- CHECK DTC OUTPUT (HYBRID CONTROL)
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG).
- Enter the following menus: Powertrain / Plug-in Control / Trouble Codes.
- Check if DTCs are output.
Result
Result Proceed to Only P0D53-408 or P0D54-409 is output or P0D53-408, P0D54-409 and DTCs other than U019B-440 are also output. A U019B-440 is output. B - Turn the power switch off.
B → See step 3
A: Go to next step
- CHECK ELECTRIC VEHICLE CHARGER ASSEMBLY (ICHG SENSOR OUTPUT VOLTAGE) See step 8
NG → See step 4
OK → See step 5
- GO TO DTC CHART (U019B-440). Refer to DTC U019B-440: Lost Communication with Battery Charger Control Module [08/2014 - ]
- REPLACE ELECTRIC VEHICLE CHARGER ASSEMBLY. Refer to COMPONENTS [08/2014 - ]
- REPLACE PLUGIN CHARGE CONTROL ECU ASSEMBLY. Refer to COMPONENTS [08/2014 - ]