LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2015 >> Prius Plug-in >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Plug-In Charge Control System - Diagnostic Codes & Circuit Tests (Plug-In) >> Plug-In Charge Control System >> DTC P0D08-755: Charger Positive Relay Stuck Closed [08/2014 - ] >> Confirmation Driving Pattern
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Confirmation Driving Pattern

  1. Connect the Techstream to the DLC3.
  2. Turn the power switch on (IG) and turn the Techstream on.
  3. Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
  4. Turn the power switch off.
  5. Connect the charging cable, plug-in charge the vehicle for at least 1 minute, and then disconnect the charging cable.
  6. Turn the power switch on (IG) and turn the Techstream on.
  7. Enter the following menus: Powertrain / Plug-in Control / Trouble Codes.
  8. Check that the permanent DTCs are cleared.
  9. If the permanent DTCs are not cleared, perform a universal trip, and then check for permanent DTCs again.

    HINT: 

    • If a permanent DTC is output, the system is malfunctioning.
    • If no permanent DTC is output, the system is normal.
scientia non olet · About LEMON Manuals