LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2015 >> Prius Three >> Repair and Diagnosis (Single Page) >> Hybrid/Electric Powertrain >> Testing and Diagnosis >> Hybrid Control System (Diagnostic Codes (P0069-273 - P0A75-336)) (Except Plug-In) >> Hybrid Control System >> DTC P0A1B-168: Drive Motor "A" Control Module; DTC P0A1B-795: Drive Motor "A" Control Module; DTC P0A1B-796: Drive Motor "A" Control Module [08/2014 - ] >> Confirmation Driving Pattern
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Confirmation Driving Pattern

Fig 1: Identifying Power Switch / Scantool Operation Graph
GTY438165Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  1. Connect the Techstream to the DLC3.
  2. Turn the power switch on (IG) and turn the Techstream on.
  3. Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
  4. Turn the power switch off and wait for 30 seconds or more.
  5. Turn the power switch on (IG) and wait for 5 seconds or more.
  6. Turn the power switch on (READY) with park (P) selected and wait for 5 seconds or more. [A]
  7. Drive the vehicle at 3 mph (5 km/h) or more for 5 seconds or more. [B]
  8. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes. [C]
  9. Read the current DTCs.

    HINT: 

    • If a current DTC is output, the system is malfunctioning.
    • If a current DTC is not output and want to confirm permanent DTC, perform the following procedure.
  10. Check that permanent DTCs are cleared.
  11. If the permanent DTCs are not cleared, perform the universal trip, and then check for permanent DTCs again.
scientia non olet · About LEMON Manuals