Confirmation Driving Pattern
WARNING: This page is about a different variant/trim than selected.
- Connect the Techstream to the DLC3.
- Turn the power switch on (IG) and turn the Techstream on.
- Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
- Turn the power switch off.
- Turn the power switch on (IG) and turn the Techstream on.
- Enter the following menus: Powertrain / Plug-in Control / Data List.
- Check that "State of Charge (All Bat)" shows 70% or less.
- Turn the power switch off.
- Connect the charging cable, fully charge the vehicle, and then disconnect the charging cable.
HINT:
The maximum time required to fully charge the vehicle is about 3 hours and 30 minutes when using AC 100 V or about 2 hours when using AC 200 V.
- Turn the power switch on (IG) and turn the Techstream on.
- Enter the following menus: Powertrain / Plug-in Control / Trouble Codes.
- Check that the permanent DTCs are cleared.
- If the permanent DTCs are not cleared, perform a universal trip, and then check for permanent DTCs again.
HINT:
- If a permanent DTC is output, the system is malfunctioning.
- If no permanent DTC is output, the system is normal.