Front Passenger Side Door Entry Unlock Function does not Operate [08/2014 - ]: Procedure

1. When the door control switch on the master switch assembly is operated, check that the doors unlock and lock according to switch operation. Refer to OPERATION CHECK [08/2014 - ] .

   OK

   Door locks operate normally.

NG → See step   6 

OK: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Main Body / Data List.
5. Read the Data List according to the display on the Techstream.
   MAIN BODY (MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU))
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   FR Door Lock Pos	Front passenger side door lock position switch signal/LOCK or UNLOCK	LOCK: Front passenger side door locked UNLOCK: Front passenger side door unlocked	-

   OK

   On the Techstream screen, the display changes between LOCK and UNLOCK as shown in the chart above.

NG → See step   9 

OK: Go to next step 

1. Enter the following menus: Body Electrical / Smart Key / Data List.
2. Read the Data List according to the display on the Techstream.
   SMART KEY (CERTIFICATION ECU (SMART KEY ECU ASSEMBLY))
   
   

   Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
   P-Door Touch Sensor	Status of touch sensor (for front passenger side) / ON or OFF	ON: Touch sensor touched OFF: Touch sensor not touched	-

   OK

   On the Techstream screen, the display changes between ON and OFF as shown in the chart above.

NG → See step   4 

OK → See step   7 

1. Disconnect the certification ECU (smart key ECU assembly) connector.
2. Disconnect the front door outside handle assembly (for front passenger side) connector.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   L62-21 (SEN2) - z4-4 (SENS)	Always	Below 1 Ω
   L62-21 (SEN2) - Body ground	Always	10 kΩ or higher
   z4-4 (SENS) - Body ground	Always	10 kΩ or higher

   TEXT IN ILLUSTRATION
   
   

   *1	Front view of wire harness connector (to Certification ECU (Smart Key ECU Assembly))
   *2	Front view of wire harness connector (to Front Door Outside Handle Assembly (for Front Passenger Side))

NG → REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: Go to next step 

1. Reconnect the certification ECU (smart key ECU assembly) connector.
2. Reconnect the front door outside handle assembly (for front passenger side) connector.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

3. Measure the voltage and check for pulses according to the value(s) in the table below.

   Standard

   Tester Connection	Condition	Specified Condition
   L62-21 (SEN2) - L62-15 (E)	Power switch off All doors closed Key not in detection area Touch sensor (for front passenger side) not touched	Pulse generation
   L62-21 (SEN2) - L62-15 (E)	Power switch off All doors closed Key not in detection area Touch sensor (for front passenger side) touched	Below 2 V

   TEXT IN ILLUSTRATION
   
   

   *1

   Component with harness connected (Certification ECU (Smart Key ECU Assembly))

   -

   -

NG → See step   8 

OK → See step   7