April 5, 2026: LEMON Manuals is launched! Read the announcement.

Check Mode Procedure [08/2014 - ]

WARNING: This page is about a different variant/trim than selected.

CHECK MODE (SIGNAL CHECK): DTC CHECK
1. Turn the power switch off.
2. Connect the Techstream to the DLC3.
3. Turn the power switch on (IG).
4. Turn the Techstream on.
5. Enter the following menus: Body Electrical / SRS Airbag / Utility / Signal Check, and proceed with checking using the Techstream.
  NOTE:
  Select Signal Check screen on the Techstream to clear the output DTCs (both current and history).
  
  HINT:
  - DTCs can be detected more sensitively in check mode than in normal diagnosis mode.
  - Perform check mode inspection when a malfunction in a squib circuit is suspected even after the normal system code is output through normal diagnosis mode inspection.