DTC B1795: Occupant Classification ECU Malfunction [08/2014 - ]: Procedure

1. Turn the power switch off.
2. Disconnect the cable from the negative (-) auxiliary battery terminal.
3. Replace the occupant classification ECU. Refer to REMOVAL [08/2014 - ] .

NEXT: Go to next step 

1. Connect the cable to the negative (-) auxiliary battery terminal.
2. Connect the Techstream to the DLC3.
3. Turn the power switch on (IG).
4. Using the Techstream, perform Zero Point Calibration. Refer to INITIALIZATION [08/2014 - ] .

   OK

   "Zero Point Calibration is complete." is displayed.

NEXT: Go to next step 

1. Using the Techstream, perform Sensitivity Check. Refer to INITIALIZATION [08/2014 - ] .

   Standard

   27 to 33 kg (59.5 to 72.8 lb)

NEXT → END