Typical Enabling Conditions
ALL
| Monitor runs whenever following DTCs are not stored | None |
P0335: CRANKSHAFT POSITION SENSOR VERIFY PULSE INPUT (CASE 1)
| All of the following conditions are met | - |
| Power switch | On (IG) |
| Time after power switch off to on (IG) | 0.5 seconds or more |
| Lost communication with power management control ECU (U0293) | Not detected |
P0335: CRANKSHAFT POSITION SENSOR VERIFY PULSE INPUT (CASE 2)
| All of the following conditions are met | - |
| Time after power switch off to on (IG) | 0.5 seconds or more |
| Engine speed (Top dead center) | 600 rpm or higher |
| Engine speed (30°CA) | 600 rpm or higher |
| Starter | OFF |
| Time after starter ON to OFF | 3 seconds or more |
| Lost communication with power management control ECU (U0293) | Not detected |
P0335: CRANKSHAFT POSITION SENSOR RANGE CHECK/RATIONALITY
| All of the following conditions are met | - |
| Engine speed signal | Signal input |
| Power switch | On (IG) |
| Time after starter OFF to ON | 2.5 seconds or more |
| Camshaft position sensor circuit fail | Not detected |
| Number of camshaft position sensor signal pulse | 6 times |
| Auxiliary Battery voltage | 7 V or higher |
| Lost communication with power management control ECU (U0293) | Not detected |