LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2015 >> Prius V Two >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Collision/Avoidance >> Rear View Monitor System - (Diagnostics - Introduction) >> Rear View Monitor System >> DTC Check/Clear [11/2014 - ] >> DTC Check/Clear [11/2014 - ]
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC Check/Clear [11/2014 - ]

  1. CHECK DTC 
    1. Connect the Techstream to the DLC3.
    2. Turn the power switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical / Navigation System / Trouble Codes.
    5. Check for DTCs. Refer to DIAGNOSTIC TROUBLE CODE TABLE [11/2014 - ] .
      NOTE:

      The navigation receiver assembly*1 or radio and display receiver assembly*2 outputs DTCs for the following system. When DTCs other than those in Diagnostic Trouble Code Table for the rear view monitor system are output, refer to Diagnostic Trouble Code Table for the relevant systems.

      System Proceed to
      Navigation System*1 Refer to DIAGNOSTIC TROUBLE CODE TABLE [11/2014 - ]
      Audio and Visual System*2 Refer to DIAGNOSTIC TROUBLE CODE TABLE [11/2014 - ]
      • *1: for Navigation System
      • *2: for Audio and Visual System
  2. CLEAR DTC 
    1. Connect the Techstream to the DLC3.
    2. Turn the power switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical / Navigation System / Trouble Codes.
    5. Clear the DTCs.
scientia non olet · About LEMON Manuals