LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2015 >> Prius V Two >> Repair and Diagnosis (Single Page) >> Body & Frame >> Door Locks >> Smart Key System - Keyless Entry - (Diagnostic Codes & Symptom Tests) >> Smart Key System (For Entry Function) >> Symptom Tests >> All Door Entry Lock/Unlock Functions and Wireless Functions do not Operate [11/2014 - ] >> Inspection Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Inspection Procedure

NOTE:
  • The smart key system (for Entry Function) uses the CAN communication system and LIN communication system. First inspect the communication systems by following How to Proceed with Troubleshooting. Refer to HOW TO PROCEED WITH TROUBLESHOOTING [11/2014 - ] . Troubleshoot the smart key system (for Entry Function) after confirming that the communication systems are functioning properly.
  • When using the Techstream with the power switch off to troubleshoot:

    Connect the Techstream to the DLC3 and turn a courtesy light switch on and off at 1.5-second intervals until communication between the Techstream and vehicle begins.

  • Check that there are no electrical key transmitter sub-assemblies in the vehicle.
  • Before performing the inspection, check that DTC B1242 (wireless door lock control) is not output. Refer to DTC CHECK / CLEAR [11/2014 - ] .
  • Inspect the fuses for circuits related to this system before performing the following inspection procedure.
  • Before replacing the certification ECU (smart key ECU assembly), refer to the smart key system (for Entry Function). Refer to PRECAUTION [11/2014 - ] .
  • After repair, confirm DTC not reoccur with performing the "DTC Output Confirmation Operation".
  • Door control receiver has a constant voltage (5 V) supply circuit connected to terminal "+5".
scientia non olet · About LEMON Manuals