Rear Power Window LH does not Operate with Rear Power Window Switch LH [08/2013 - ]: Procedure

1. Disconnect the K1 rear power window regulator switch assembly (for LH door) connector.
2. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   K1-3 (B) - Body ground	Ignition switch ON	11 to 14 V

   Result

   Proceed to
   OK
   NG

Result:  2

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Result:  1

OK 

See step  2

1. Remove the rear power window regulator switch assembly (for LH door).

   Refer to REMOVAL [08/2013 - ]

2. Inspect the rear power window regulator switch assembly (for LH door).

   Refer to INSPECTION [08/2013 - ]

   Result

   Proceed to
   OK
   NG

Result:  2

NG 

REPLACE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY (FOR LH DOOR):  REMOVAL [08/2013 - ] 

Result:  1

OK 

See step  3

1. Disconnect the K2 power window regulator motor assembly (for rear LH door) connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   K1-4 (U) - K2-1 (U)	Always	Below 1 Ω
   K1-1 (D) - K2-2 (D)	Always	Below 1 Ω
   K1-4 (U) - Body ground	Always	10 kΩ or higher
   K1-1 (D) - Body ground	Always	10 kΩ or higher
   K2-1 (U) - Body ground	Always	10 kΩ or higher
   K2-2 (D) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result:  2

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Result:  1

OK 

See step  4

1. Remove the power window regulator master switch assembly.

   Refer to REMOVAL [08/2013 - ]

2. Inspect the power window regulator master switch assembly.

   Refer to INSPECTION [08/2013 - ]

   Result

   Proceed to
   OK
   NG

Result:  2

NG 

REPLACE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY:  REMOVAL [08/2013 - ] 

Result:  1

OK 

See step  5

1. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   H5-12 (U) - K1-5 (SU)	Always	Below 1 Ω
   H5-13 (D) - K1-2 (SD)	Always	Below 1 Ω
   H5-12 (U) - Body ground	Always	10 kΩ or higher
   H5-13 (D) - Body ground	Always	10 kΩ or higher
   K1-5 (SU) - Body ground	Always	10 kΩ or higher
   K1-2 (SD) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result:  1

OK 

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR REAR LH DOOR). Refer to  REMOVAL [08/2013 - ] 

Result:  2

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR