Adjustment [08/2013 - ]: Procedure
WARNING: This page is about a different variant/trim than selected.
- ADJUST SHIFT LEVER POSITION
- Apply the parking brake and move the shift lever to N.
- Remove the rear console box assembly.
Refer to REMOVAL [08/2013 - 08/2016] Refer to REMOVAL [08/2016 - ]
- Separate the end of the transmission control cable assembly from the transmission floor shift assembly.
- Using a screwdriver, pull out the stopper of the transmission control cable assembly.
*a Stopper NOTE:Do not remove the stopper. If it is removed, reinstall it to its original position.
- Rotate the nut counterclockwise approximately 180° and, while holding the nut in that position, separate the transmission control cable assembly from the transmission floor shift assembly.
*a Stopper *b Nut NOTE:Do not rotate the nut excessively as the interior spring may come off and the transmission control cable assembly will not be reusable.
- Push the 2 claws together at the top of the lock piece. While holding the 2 claws together, push the 2 lugs on the bottom of the lock piece toward each other and upward to push up the lock piece.
*a Lock Piece *b Bottom View *c Push *d Push up - Turn the nut of the transmission control cable assembly 180° counterclockwise. While holding the nut in place, push in the stopper until it clicks twice.
*a Stopper *b Nut *c Push in - - - Connect the transmission control cable assembly to the transmission floor shift assembly. Check that the spring is positioned at "A" and push in the stopper.
*1 Transmission Floor Shift Assembly - - *a Stopper *b Spring *c Nut *d Push in NOTE:- If the stopper cannot be pushed in, slightly turn the nut clockwise and then push in the stopper again.
- Make sure that the transmission control cable assembly is securely locked.
- Install the end of the transmission control cable assembly to the transmission floor shift assembly.
*a Lock Piece NOTE:- Install the end of the transmission control cable assembly all the way to the base of the pin.
- Install the end of the transmission control cable assembly so that its adjustment lock section is on the driver side.
- Check that the lock piece is pulled up.
- Push the lock piece into the adjuster case.
*a Lock Piece *b Adjuster Case *c Push in NOTE:- Check that the park/neutral position switch assembly and shift lever are in neutral.
- Securely push in the lock piece until the slider lock is engaged.
- After adjusting the shift lever position, check the operation and function of the shift lever. If there is a problem, adjust the position again.
- Install the rear console box assembly.
Refer to INSTALLATION [08/2013 - 08/2016] Refer to INSTALLATION [08/2016 - ]