DTC P062F: Internal Control Module EEPROM Error [12/2013 - 11/2015]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Clear the DTCs.

   Refer to DTC CHECK / CLEAR [12/2013 - 11/2016]

   Powertrain > ECT > Clear DTCs 

5. Turn the ignition switch off and turn the Techstream off.
6. Disconnect the Techstream.
7. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.
8. Connect the cable to the negative (-) battery terminal.
9. Connect the Techstream to the DLC3.
10. Turn the ignition switch to ON.
11. Turn the Techstream on.
12. Select the following menu items: Powertrain / ECT / Trouble Codes.

    Powertrain > ECT > Trouble Codes 

13. Read DTCs.

    Result

    Result	Proceed to
    DTCs are not output	A
    DTC P062F is output	B

Result:  1

A 

CHECK FOR INTERMITTENT PROBLEMS. Refer to  ELECTRONIC CIRCUIT INSPECTION PROCEDURE [12/2013 - ] 

Result:  2

B 

REPLACE TCM. Refer to  COMPONENTS [12/2013 - 11/2016]