Installation [11/2015 - ]: Procedure

1. When using a new pre-collision city sensor:
   1. Remove the protective cover from the pre-collision city sensor.
      NOTE:

      Do not touch the camera lens after removing the protective cover.

2. Engage the 2 guides and 2 claws to install the pre-collision city sensor as shown in the illustration.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   TEXT IN ILLUSTRATION
   
   

   *a

   32 to 54°

   NOTE:

   Do not touch the camera lens.

   HINT: 

   Insert the pre-collision city sensor into the bracket at an angle between 32° and 54°.

3. Check that the claws are securely engaged as shown in the illustration.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   TEXT IN ILLUSTRATION
   
   

   *a	Correct
   *b	Incorrect

4. Connect the connector.

1. Engage the 2 guides and 2 clips as shown in the illustration to install the pre-collision city cover.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Engage the 2 guides and 2 claws as shown in the illustration to install the pre-collision city cover 2nd.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

If the pre-collision city sensor has been replaced with a new one or the windshield glass has been replaced or removed and installed, it is necessary to perform Pre-Collision City Sensor Learning (Refer to ADJUSTMENT [11/2015 - ] ).