How To Proceed With Troubleshooting [08/2015 - 08/2019]: Procedure

Result

Result: 

NEXT 

See step  2

Standard voltage

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding.

Result

Result: 

NEXT 

See step  3

Result

Result: 

NEXT 

See step  4

1. Check for DTCs and note any codes that are output (Refer to DTC CHECK / CLEAR [08/2015 - 08/2019] ).
2. Clear the DTCs (Refer to DTC CHECK / CLEAR [08/2015 - 08/2019] ).
3. Recheck for DTCs. Try to duplicate the DTC (SFI system and engine immobiliser system) by reproducing the symptoms indicated by the DTC.

   Result

   Result	Proceed to
   DTC is not output	A
   SFI system DTC is output	B
   Engine immobiliser system DTC is output	C

Result: 

B 

GO TO SFI SYSTEM 

(Refer to HOW TO PROCEED WITH TROUBLESHOOTING [08/2015 - ] )

Result: 

C 

GO TO DIAGNOSTIC TROUBLE CODE CHART 

(Refer to DIAGNOSTIC TROUBLE CODE CHART [08/2015 - 08/2019] )

Result: 

A 

See step  5

1. Refer to Problem Symptoms Table (Refer to PROBLEM SYMPTOMS TABLE [08/2015 - 08/2019] ).

   Result

   Result	Proceed to
   Fault is not listed in problem symptoms table	A
   Fault is listed in problem symptoms table	B

Result: 

B 

See step  7

Result: 

A 

See step  6

1. Data List / Active Test (Refer to DATA LIST / ACTIVE TEST [08/2015 - 08/2019] ).
2. Terminals of ECU (Refer to TERMINALS OF ECU [08/2015 - 08/2019] ).

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  7

Result

Result: 

NEXT 

See step  8

Result

Result: 

NEXT 

END