DTC B27A1: Open in Driver Side Electrical Antenna Circuit [08/2015 - 08/2019]: Procedure

1. Turn the engine switch off.
2. Check that the connectors are properly connected to the certification ECU and front door outside handle assembly (for driver side).

   OK

   Connectors are properly connected.

Result: 

NG 

CONNECT CONNECTORS PROPERLY 

Result: 

OK 

See step  2

1. Disconnect the M1 handle connector.
2. Disconnect the F79 ECU connector.
3. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   M1-3 (ANT2) - F79-4 (CG1B)	Always	Below 1 Ω
   M1-6 (ANT1) - F79-3 (CLG1)	Always	Below 1 Ω
   M1-2 (GND) - Body ground	Always	Below 1 Ω
   F79-4 (CG1B) - Body ground	Always	10 kΩ or higher
   F79-3 (CLG1) - Body ground	Always	10 kΩ or higher
   F79-15 (E) - Body ground	Always	Below 1 Ω

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Result: 

OK 

See step  3

1. Measure the voltage according to the value(s) in the table below.

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

   TEXT IN ILLUSTRATION
   
   

   *a

   Component with harness connected (Certification ECU)

   -

   -

   OK

   Tester Connection	Switch Condition	Specified Condition
   F79-3 (CLG1) - F79-15 (E)	Engine switch off, all doors closed, key not in cabin and transmitter lock switch not pressed → pressed	No pulse generation → Pulse generation
   F79-4 (CG1B) - F79-15 (E)	Engine switch off, all doors closed, key not in cabin and transmitter lock switch not pressed → pressed	No pulse generation → Pulse generation

Result: 

NG 

REPLACE CERTIFICATION ECU 

(Refer to REMOVAL [08/2015 - 08/2019] )

Result: 

OK 

See step  4

1. Temporarily replace the front door outside handle assembly (for driver side) with a new or normally functioning one (Refer to DISASSEMBLY [08/2015 - ] ).

Result: 

NEXT 

See step  5

1. Clear the DTCs (Refer to DTC CHECK / CLEAR [08/2015 - 08/2019] ).
2. Check for DTCs (Refer to DTC CHECK / CLEAR [08/2015 - 08/2019] ).

   OK

   DTC B27A1 is not output.

Result: 

OK 

END (FRONT DOOR OUTSIDE HANDLE ASSEMBLY IS DEFECTIVE) 

Result: 

NG 

REPLACE CERTIFICATION ECU 

(Refer to REMOVAL [08/2015 - 08/2019] )