LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2017 >> 86 Base, Automatic Trans >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Wiper/Washer Systems >> Wiper System / Washer System (Service Information) >> Wiper Switch >> Installation [03/2017 - ] >> Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Installation [03/2017 - ]: Procedure

  1. INSTALL WINDSHIELD WIPER SWITCH ASSEMBLY 
    GTY471658Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    1. Engage the claw and install the windshield wiper switch assembly as shown in the illustration.
    2. Connect each connector.
  2. INSTALL UPPER STEERING COLUMN COVER 
    1. Engage the 2 claws and install the upper steering column cover.
  3. INSTALL LOWER STEERING COLUMN COVER 
    1. Engage the 6 claws and install the lower steering column cover.
    2. While turning the steering wheel assembly to the right and left, install the 2 screws.
  4. INSTALL STEERING COLUMN COVER SUPPORT (w/ Smart Key System) 
    1. Engage the 4 claws and install the steering column cover support.
  5. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 3

  6. INSTALL UPPER INSTRUMENT PANEL METER ORNAMENT 

    Refer to PROCEDURE - Step 5

  7. INSTALL METER HOOD SUB-ASSEMBLY 

    Refer to PROCEDURE - Step 6

  8. INSTALL INSTRUMENT PANEL ORNAMENT 

    Refer to PROCEDURE - Step 4

  9. INSTALL INSTRUMENT SIDE PANEL LH 

    Refer to PROCEDURE - Step 8

scientia non olet · About LEMON Manuals