Fail-Safe Chart [06/2016 - 07/2018]
If any of the following DTCs are stored, the ECM enters fail-safe mode to allow the vehicle to be driven temporarily or stops fuel injection.
| DTC Code | Fail-Safe Operation | Fail-Safe Deactivation Condition |
|---|---|---|
| P000A P000C P0010 P0011 P0016 P0018 P0020 P0021 P0341 P0345 P0346 |
Fix intake VVT control at intermediate position | After recovery in normal status, turn the ignition switch to ON again |
| P000B P000D P0013 P0014 P0017 P0019 P0023 P0024 P0365 P0366 P0390 P0391 |
Fix exhaust VVT control at maximum advanced angle | After recovery in normal status, turn the ignition switch to ON again |
| P0031 P0032 P0131 P0132 P0134 |
Stop air fuel ratio feedback control | After recovery in normal status, turn the ignition switch to ON again |
| P0037 P0137 P0138 P013A P013B P013E P013F P0141 P2270 P2271 |
Stop air fuel ratio secondary feedback control | Return to normal status |
| P0087 P0088 P0191 P0192 P0193 P1192 P1193 P1235 |
|
After recovery in normal status, turn the ignition switch to ON again |
| P0101 P0102 P0103 |
Make the engine load the manifold absolute pressure converted estimated value | Return to normal status |
| P0068 P0107 P0108 |
Make the manifold absolute pressure value the mass air flow meter converted estimated value | Return to normal status |
| P0111 P0112 P0113 |
Fix inlet air temperature at 20°C (68°F) | Return to normal status |
| P0116 P0117 P0118 P0125 |
|
Return to normal status |
| P0172 | Stop purge control | Return to normal status |
| P0196 P0197 P0198 |
Fix engine oil temperature at 70°C (158°F) | Return to normal status |
| P0201 P0202 P0203 P0204 P062D P1261 P1262 P1263 P1264 |
|
After recovery in normal status, turn the ignition switch to ON again |
| P062F P0122 P0123 P0222 P0223 P0604 P0605 P0606 P060A P060B P1160 P2101 P2102 P2103 P2109 P2119 P2135 |
Stop electronic throttle control, and fix the throttle valve opening angle (5 degrees) | After recovery in normal status, turn the ignition switch to ON again |
| P0327 P0328 P0332 P0333 |
Maximum retard angle | Return to normal status |
| P0451 | Stop leak detection pump control | Return to normal status |
| P0851 P0852 |
Turn off the gear position display within the combination meter (for Manual Transmission) | Return to normal status |
| P1451 P2404 |
Fix atmospheric pressure at 101.3 kPa (760 mmHg) | Return to normal status |
| P2122 P2123 P2127 P2128 |
Accelerator pedal sensor assembly has 2 sensor circuits: Main and Sub If either circuit malfunctions, substitute the normal accelerator position sensor until the prescribed angle. If both circuits malfunction, fix accelerator position at prescribed angle (12%). |
After recovery in normal status, turn the ignition switch to ON again |
| P2138 |
|
After recovery in normal status, turn the ignition switch to ON again |
| P2158 | Fix ECU recognized vehicle speed at 10 km/h (6.2 mph) | Return to normal status |