Caution / Notice / Hint

NOTE:

When using the Techstream with the engine switch off, connect the Techstream to the vehicle and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the Techstream and the vehicle begins. Then select the vehicle type under manual mode and enter the following menus: Body Electrical / Smart Key. While using the Techstream, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the Techstream and the vehicle.
The steering lock system uses LIN communication. First perform the inspections in "How to Proceed with Troubleshooting" to confirm that there are no communication malfunctions before proceeding with troubleshooting.
Refer to HOW TO PROCEED WITH TROUBLESHOOTING [06/2016 - ]
Before replacing the steering lock actuator assembly (steering lock ECU), refer to Registration.
Refer to REGISTRATION [03/2017 - 12/2017] Refer to REGISTRATION [12/2017 - ]
After performing repairs, confirm that no DTCs are output again.

HINT:

When all the ECUs that are connected to the LIN communication cannot communicate with the certification ECU (smart key ECU assembly), DTC B2785 is stored.