How To Proceed With Troubleshooting [06/2016 - ]: Procedure

Result

Result: 

NEXT 

See step  2

1. Measure the battery voltage with the ignition switch off.

   Standard Voltage

   11 to 14 V

   If the voltage is below 11 V, replace or recharge the battery before proceeding to the next step.

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  3

1. Use the Techstream to check if the CAN communication system is functioning normally.

   Result

   Result	Proceed to
   CAN DTC is not output	A
   CAN DTC is output	B

Result: 

B 

GO TO CAN COMMUNICATION SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [06/2016 - 03/2017]  Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [03/2017 - ] 

Result: 

A 

See step  4

Refer to DTC Check / Clear.

Refer to DTC CHECK / CLEAR [06/2016 - ] 

1. Check for DTCs and note any codes that are output.
2. Clear the DTCs.
3. Recheck for DTCs. Try to reproduce the DTCs by duplicating the conditions indicated by the DTCs.

   Result

   Result	Proceed to
   DTC does not reoccur	A
   DTC reoccurs	B

Result: 

B 

GO TO DTC CHART. Refer to  DIAGNOSTIC TROUBLE CODE CHART [06/2016 - ]  

Result: 

A 

See step  5

1. Perform the road test.

   Refer to ROAD TEST [06/2016 - ] 

2. Check that cruise control is not canceled by other than canceling operations by the driver.

   Result

   Result	Proceed to
   Cruise control is cancelled	A
   Cruise control is not cancelled	B

Result: 

B 

See step  8

Result: 

A 

See step  6

HINT: 

The driver's history of canceling cruise control is also stored.

1. Check "CANCEL CODE".

   Refer to CANCEL CODE [06/2016 - ] 

   Result

   Result	Proceed to
   "CANCEL CODE" is not detected	A
   "CANCEL CODE" is detected	B

Result: 

B 

ADJUST, REPAIR OR REPLACE ACCORDING TO "CANCEL CODE" 

Result: 

A 

See step  7

Refer to Problem Symptoms Table.

Refer to PROBLEM SYMPTOMS TABLE [06/2016 - ] 

Result

Result: 

B 

ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE 

Result: 

A 

See step  8

1. Terminals of ECU

   Refer to TERMINALS OF ECM [06/2016 - ] 

2. Data List / Active Test

   Refer to DATA LIST / ACTIVE TEST [06/2016 - ] 

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  9

Result

Result: 

NEXT 

See step  10

Result

Result: 

NEXT 

END