DTC Check / Clear [03/2017 - ]

NOTE:

When using the Techstream with the vehicle engine switch off, connect the Techstream to the vehicle and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the Techstream and the vehicle begins. Then select the vehicle type under manual mode and enter the following menus: Body Electrical / Smart Key. While using the Techstream, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the Techstream and the vehicle.

CHECK DTC (POWER SOURCE CONTROL)
1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Power Source Control / Trouble Codes.
5. Check for DTCs.
  HINT:
  
  Refer to the Techstream operator's manual for further details.
CHECK DTC (SMART KEY)
1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Smart Key / Trouble Codes.
5. Check for DTCs.
  HINT:
  
  Refer to the Techstream operator's manual for further details.
CHECK DTC (ENGINE)
1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Powertrain / Engine / Trouble Codes.
5. Check for DTCs.
  HINT:
  
  Refer to the Techstream operator's manual for further details.
CLEAR DTC (POWER SOURCE CONTROL)
1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Power Source Control / Trouble Codes.
5. Clear the DTCs by following the directions on the Techstream display.
  HINT:
  
  Refer to the Techstream operator's manual for further details.
CLEAR DTC (SMART KEY)
1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Smart Key / Trouble Codes.
5. Clear the DTCs by following the directions on the Techstream display.
  HINT:
  
  Refer to the Techstream operator's manual for further details.
CLEAR DTC (ENGINE)
1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Turn the Techstream on.
4. Enter the following menus: Powertrain / Engine / Trouble Codes.
5. Clear the DTCs by following the directions on the Techstream display.
  HINT:
  
  Refer to the Techstream operator's manual for further details.