Installation [06/2016 - 03/2017]: Procedure

INSTALL STEERING SENSOR
1. Align the 2 pins and 2 guides, and engage the 6 claws to install the steering sensor to the spiral cable sub-assembly.
  NOTE:
  Do not rotate the spiral cable until the steering sensor has been attached to it.
ALIGN FRONT WHEELS TO FACING STRAIGHT AHEAD
INSTALL SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY
Refer to PROCEDURE - Step 3
INSTALL UPPER STEERING COLUMN COVER
Refer to PROCEDURE - Step 5
INSTALL LOWER STEERING COLUMN COVER
Refer to PROCEDURE - Step 6
INSPECT AND ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY
Refer to PROCEDURE - Step 12
INSTALL UPPER INSTRUMENT PANEL METER ORNAMENT
Refer to PROCEDURE - Step 5
INSTALL METER HOOD SUB-ASSEMBLY
Refer to PROCEDURE - Step 6
INSTALL INSTRUMENT PANEL ORNAMENT (w/ Large Ornament Panel)
Refer to PROCEDURE - Step 14
INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (w/o Large Ornament Panel)
Refer to PROCEDURE - Step 15
INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
Refer to PROCEDURE - Step 3
INSTALL INSTRUMENT SIDE PANEL LH
Refer to PROCEDURE - Step 8
INSTALL STEERING WHEEL ASSEMBLY
(Refer to INSTALLATION [06/2016 - ] )
INSPECT SRS WARNING LIGHT
(Refer to DIAGNOSIS SYSTEM [06/2016 - ] )
PERFORM VSC SENSOR NEUTRAL MEMORIZATION
(Refer to CALIBRATION [06/2016 - ] )