DTC P0700: Transmission Control System (MIL Request) [06/2016 - ]: Procedure

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Enter the following menus: Powertrain / ECT / Trouble Codes.
5. Read DTCs.
   RESULT
   
   

   Result	Proceed to
   DTC is not output	A
   DTC is output	B

Result: 

B 

GO TO AUTOMATIC TRANSMISSION SYSTEM 

(Refer to HOW TO PROCEED WITH TROUBLESHOOTING [06/2016 - ] )

Result: 

A 

See step  2

1. Connect the Techstream to the DLC3.
2. Turn the ignition switch to ON.
3. Turn the Techstream on.
4. Clear the DTC (Refer to DTC CHECK / CLEAR [06/2016 - ] ).
5. Turn the ignition switch off and wait for at least 30 seconds.
6. Turn the ignition switch to ON.
7. Turn the Techstream on.
8. Enter the following menus: Powertrain / Engine / Trouble Codes.
9. Read DTCs.
   RESULT
   
   

   Result	Proceed to
   DTC is not output	A
   DTC P0700 is output	B

Result: 

A 

CHECK FOR INTERMITTENT PROBLEMS 

(Refer to CHECK FOR INTERMITTENT PROBLEMS [06/2016 - ] )

Result: 

B 

REPLACE ECM 

(Refer to REMOVAL [06/2016 - ] )