LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2017 >> 86 Base, Standard Trans >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Anti-Theft Systems >> Smart Key System (Keyless Entry) - Diagnostic Codes & Symptom Tests >> SMART KEY SYSTEM(for Entry Function) >> Symptom Tests >> Room Oscillator does not Recognize Key [03/2017 - 12/2017] >> Caution / Notice / Hint
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Caution / Notice / Hint

NOTE:
  • When using the Techstream with the vehicle engine switch off, connect the Techstream to the vehicle and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the Techstream and the vehicle begins. Then select the vehicle type under manual mode and enter the following menus: Body Electrical / Smart Key. While using the Techstream, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the Techstream and the vehicle.
  • The smart key system (for Entry Function) uses a LIN communication system and CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting (Refer to HOW TO PROCEED WITH TROUBLESHOOTING [03/2017 - ] ). Troubleshoot the smart key system (for Entry Function) after confirming that the communication system is functioning properly.
  • Before replacing the certification ECU (smart key ECU assembly), refer to the smart key system (for Entry Function) (Refer to PRECAUTION [03/2017 - ] ).
  • Indoor electrical key oscillator has an antenna coil between each two CLG terminals.

HINT: 

Check that the entry cancel function, which is one of the customizing settings of the smart key system, is not set (Refer to CUSTOMIZE PARAMETERS [03/2017 - ] ).