LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2017 >> 86 Base, Standard Trans >> Repair and Diagnosis >> General Information >> Reset Procedures >> Tire Pressure Monitor Systems >> TPMS Reset Procedures >> Tire Pressure Sensor Registration >> Register Transmitter ID
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Register Transmitter ID

  1. Set the tire pressure of all wheels to the pressure specified on the tire and loading information label.
  2. With ignition OFF, connect the Techstream to DLC3.
  3. Turn ignition switch to ON position. Turn Techstream ON.
  4. Enter the following menus: Chassis / Tire Pressure Monitor / Utility / ID Registration.
  5. Perform the procedures displayed on the Techstream.
    NOTE: If registration is not completed within 300 seconds, ID registration is canceled.
NOTE: After all IDs are registered, DTC C2126 is stored in the door control receiver and the tire pressure warning light blinks for 1 minute and then comes on. When the door control receiver successfully receives radio waves from all the transmitters whose IDs are stored in the door control receiver, DTC C2126 is cleared and the tire pressure warning light goes off. If the IDs have not been registered, DTC C2171 is stored in the door control receiver after 3 minutes or more. After all IDs are registered, DTC C2126 is stored in the door control receiver and the tire pressure warning light blinks for 1 minute and then illuminates. When the door control receiver successfully receives signals from all the transmitters whose IDs are stored in the ECU, DTC C2126 is cleared and the tire pressure warning light goes off.
scientia non olet · About LEMON Manuals