How To Proceed With Troubleshooting [08/2013 - ]: Procedure

Result

Result:  1

NEXT 

See step  2

1. Measure the battery voltage with the ignition switch off.

   Standard Voltage

   11 to 14 V

   If the voltage is below 11 V, replace or recharge the battery before proceeding to the next step.

   Result

   Proceed to
   NEXT

Result:  1

NEXT 

See step  3

1. Use the Techstream to check if the CAN communication system is functioning normally.

   Result

   Result	Proceed to
   CAN DTCs are not output	A
   CAN DTCs are output	B

Result:  2

B 

GO TO CAN COMMUNICATION SYSTEM:  HOW TO PROCEED WITH TROUBLESHOOTING [08/2013 - ] 

Result:  1

A 

See step  4

Refer to DTC Check / Clear.

Refer to DTC CHECK / CLEAR [08/2013 - ] 

1. Check for DTCs and note any codes that are output.
2. Clear the DTCs.

   Powertrain > Cruise Control > Clear DTCs 

3. Recheck for DTCs. Try to reproduce the DTCs by duplicating the conditions indicated by the DTCs.

   Powertrain > Cruise Control > Trouble Codes 

   Result

   Result	Proceed to
   DTC does not reoccur	A
   DTC reoccurs	B

Result:  2

B 

GO TO DTC CHART:  DIAGNOSTIC TROUBLE CODE CHART [08/2013 - 04/2014]  ,  DIAGNOSTIC TROUBLE CODE CHART [04/2014 - 08/2016]  ,  DIAGNOSTIC TROUBLE CODE CHART [08/2016 - ]  

Result:  1

A 

See step  5

Refer to Problem Symptoms Table.

Refer to PROBLEM SYMPTOMS TABLE [08/2013 - 08/2016] Refer to PROBLEM SYMPTOMS TABLE [08/2016 - ] 

Result

Result:  2

B 

See step  7

Result:  1

A 

See step  6

1. Terminals of ECU

   Refer to TERMINALS OF ECM [08/2013 - 08/2016] Refer to TERMINALS OF ECM [08/2016 - ] 

2. Data List / Active Test

   Refer to DATA LIST / ACTIVE TEST [08/2013 - ] 

   Result

   Proceed to
   NEXT

Result:  1

NEXT 

See step  7

Result

Result:  1

NEXT 

See step  8

Result

Result:  1

NEXT 

END