Removal [08/2013 - ]: Procedure

WARNING: This page is about a different variant/trim than selected.

REMOVE THROTTLE BODY ASSEMBLY
Refer to REMOVAL [08/2013 - ]
REMOVE VACUUM SENSOR (MANIFOLD ABSOLUTE PRESSURE SENSOR)
Refer to REMOVAL [08/2013 - ]

REMOVE VACUUM SENSOR BRACKET

Disengage the wire harness clamp from the intake manifold.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Disengage the 2 wire harness clamps from the vacuum sensor bracket.

Disconnect the No. 1 air hose assembly from the intake manifold.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove the engine cover joint and vacuum sensor bracket from the intake manifold.

DISCONNECT NO. 1 FUEL VAPOR FEED HOSE

Disconnect the No. 1 fuel vapor feed hose from the intake manifold.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

DISCONNECT NO. 1 VENTILATION HOSE

Slide the clip and disconnect the No. 1 ventilation hose from the intake manifold.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

REMOVE INTAKE MANIFOLD

Disengage the 4 wire harness clamps.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove the bolt and wire harness clamp bracket.

Remove the 4 bolts, 2 nuts, intake manifold and intake manifold stay.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT:

If the intake manifold set bolt cannot be removed because the tip of the No. 2 generator bracket set bolt is in the way, remove the V-ribbed belt first.

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

*a	Tip of No. 2 Generator Bracket Set Bolt
*b	Intake Manifold Set Bolt

Refer to REMOVAL [08/2013 - ]

Remove the engine cover joint from the intake manifold.

REMOVE NO. 1 INTAKE MANIFOLD TO HEAD GASKET

Remove the No. 1 intake manifold to head gasket from the intake manifold.

REMOVE STUD BOLT (w/ Stud Bolt)

HINT:

If a stud bolt is deformed or the threads are damaged, replace it.

Using an E6 "TORX" socket wrench, remove the 2 stud bolts from the intake manifold.