Monitor Description
WARNING: This page is about a different variant/trim than selected.
While the engine is being cranked, starter control signal is applied to terminal STA of the ECM.
If the ECM detects the starter control (STA) signal while the vehicle is being driven, it determines that there is a malfunction in the STA circuit. The ECM then illuminates the MIL and stores this DTC.
This monitor runs when the vehicle is driven at 20 km/h (12.43 mph) or more for 20 seconds or more.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory | Note |
|---|---|---|---|---|---|---|
| P0617 | Starter Relay Circuit High | All of the following conditions are met, and a (+B) battery voltage of 10.5 V or higher is applied to the ECM for 20 seconds (1 trip detection logic):
|
|
Comes on | DTC stored | DTC for Mexico Models - Applies |
- *1: for CVT Models
- *2: for Manual Transaxle Models without Smart Key System