DTC P0106: Manifold Absolute Pressure Circuit Problem [08/2014 - 08/2016]: Procedure
- CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0106)
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Turn the Techstream on.
- Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
- Read the DTCs.
Powertrain > Engine and ECT > Trouble Codes
Result
Result Proceed to DTC P0106 is output A DTC P0106 and other DTCs are output B HINT:
If any DTCs other than P0106 are output, troubleshoot those DTCs first.
Result: 2
B
GO TO DTC CHART: DIAGNOSTIC TROUBLE CODE CHART [08/2014 - 08/2015] , DIAGNOSTIC TROUBLE CODE CHART [08/2015 - 08/2016]
Result: 1
A
See step 2
- READ VALUE USING TECHSTREAM (MAP)
- Connect the Techstream to the DLC3.
- Turn the ignition switch to ON.
- Turn the Techstream on.
- Enter the following menus: Powertrain / Engine and ECT / Data List / Primary / MAP.
Powertrain > Engine and ECT > Data List
Tester Display MAP - Read the MAP value.
- Start the engine.
- Read the MAP value at idling.
Standard
Engine Condition Techstream Display Ignition Switch ON 80 to 110 kPa(abs) [600 to 825 mmHg(abs)] Idling 20 to 40 kPa(abs) [150 to 300 mmHg(abs)] Result
Proceed to OK NG
Result: 1
OK
CHECK FOR INTERMITTENT PROBLEMS: CHECK FOR INTERMITTENT PROBLEMS [08/2013 - ]
Result: 2
NG
See step 3
- CHECK INTAKE SYSTEM
- Check the intake system for vacuum leaks.
Refer to ON-VEHICLE INSPECTION [08/2013 - ]
OK
No leaks in intake system.
HINT:
Perform "Inspection After Repair" after repairing or replacing the intake system.
Refer to INITIALIZATION [08/2013 - 08/2016]
Result
Proceed to OK NG
Result: 1
OK
REPLACE MANIFOLD ABSOLUTE PRESSURE SENSOR: REMOVAL [08/2013 - ]
Result: 2
NG
REPAIR OR REPLACE INTAKE SYSTEM
- Check the intake system for vacuum leaks.