Service Data [08/2015 - ]
WARNING: This page is about a different variant/trim than selected.
| Starter assembly | Standard current | Below 90 A at 11.5 V |
| Starter armature assembly standard resistance | Segment - Segment | Below 1 Ω |
| Segment - Armature coil core | 10 kΩ or higher | |
| Starter armature assembly commutator runout | Maximum runout | 0.05 mm (0.00197 in.) |
| Starter armature assembly commutator diameter | Standard diameter | 25.0 mm (0.984 in.) |
| Minimum diameter | 24.0 mm (0.945 in.) | |
| Starter armature assembly undercut depth | Standard depth | 0.7 mm (0.0276 in.) |
| Minimum depth | 0.2 mm (0.00787 in.) | |
| Brush length | Standard length | 11.6 mm (0.457 in.) |
| Minimum length | 7.6 mm (0.299 in.) | |
| Magnet starter switch assembly standard resistance | Terminal 50 - Switch body | Below 2 Ω |
| Engine switch | Standard resistance 5(SS1) - 6(AGND) (Not pushed) 1(SS2) - 6(AGND) (Not pushed) |
10 kΩ or higher |
| Standard resistance 5(SS1) - 6(AGND) (Pushed) 1(SS2) - 6(AGND) (Pushed) |
Below 1 Ω | |
| Ignition switch | Standard resistance Between all terminals (LOCK) |
10 kΩ or higher |
| Standard resistance 5 (AM1) - 7 (ACC) (ACC) |
Below 1 Ω | |
| Standard resistance 5 (AM1) - 7 (ACC) - 8 (IG1) (ON) |
||
| Standard resistance 3 (IG2) - 4 (AM2) (ON) |
||
| Standard resistance 5 (AM1) - 6 (ST1) - 8 (IG1) (START) |
||
| Standard resistance 2 (ST2) - 3 (IG2) - 4 (AM2) (START) |
||
| Starter relay | Standard resistance 3 - 5 |
10 kΩ or higher (Battery voltage not applied) |
| Below 1 Ω (Battery voltage applied to terminals 1 and 2) |