DTC P0705: Transmission Range Sensor Circuit Malfunction (PRNDL Input) [08/2016 - ]: Description

The park/neutral position switch assembly and shift lock control unit assembly (transmission control switch) detect the shift lever position and send signals to the ECM.

DTC No.	Detection Item	DTC Detection Condition	Trouble Area	MIL	Memory
P0705	Transmission Range Sensor Circuit Malfunction (PRNDL Input)	1. Diagnosis Condition 2. Malfunction Status 3. Malfunction Time 4. Other DTC Detection Condition 1 The ignition switch is ON and battery voltage is 10.5 V or more. 2 or more of the following signals are ON simultaneously. (NSW, P, N) input signal R input signal D input signal 2 seconds 2-trip detection logic DTC Detection Condition 2 The ignition switch is ON and battery voltage is 10.5 V or more. All signals are OFF simultaneously. NSW input signal P input signal R input signal N input signal D input signal 60 seconds 2-trip detection logic DTC Detection Condition 3 The ignition switch is ON and battery voltage is 10.5 V or more. Any of the following signals and the M signal are ON simultaneously. NSW input signal P input signal R input signal N input signal 2 seconds 2-trip detection logic	Wire harness or connector Park/neutral position switch assembly Shift lock control unit assembly (Transmission control switch) ECM	Comes on	DTC stored

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

MIL

Memory

P0705

Transmission Range Sensor Circuit Malfunction (PRNDL Input)

1. Diagnosis Condition 2. Malfunction Status 3. Malfunction Time 4. Other
DTC Detection Condition 1

The ignition switch is ON and battery voltage is 10.5 V or more.
2 or more of the following signals are ON simultaneously.
- (NSW, P, N) input signal
- R input signal
- D input signal
2 seconds
2-trip detection logic

DTC Detection Condition 2

The ignition switch is ON and battery voltage is 10.5 V or more.
All signals are OFF simultaneously.
- NSW input signal
- P input signal
- R input signal
- N input signal
- D input signal
60 seconds
2-trip detection logic

DTC Detection Condition 3

The ignition switch is ON and battery voltage is 10.5 V or more.
Any of the following signals and the M signal are ON simultaneously.
- NSW input signal
- P input signal
- R input signal
- N input signal
2 seconds
2-trip detection logic

Wire harness or connector
Park/neutral position switch assembly
Shift lock control unit assembly (Transmission control switch)
ECM

Comes on

DTC stored