Front Passenger Side Power Window does not Operate with Front Passenger Side Power Window Switch [08/2016 - ]: Procedure

1. Disconnect the H3 power window regulator switch assembly connector.
2. Measure the voltage according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   H3-3 (B) - Body ground	Ignition switch ON	11 to 14 V

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Result: 

OK 

See step  2

1. Remove the power window regulator switch assembly.

   Refer to REMOVAL [08/2016 - ]

2. Inspect the power window regulator switch assembly.

   Refer to INSPECTION [08/2016 - ]

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE POWER WINDOW REGULATOR SWITCH ASSEMBLY. Refer to  REMOVAL [08/2016 - ] 

Result: 

OK 

See step  3

1. Disconnect the H8 power window regulator motor assembly (for front passenger door) connector.
2. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   H3-4 (U) - H8-2 (U)	Always	Below 1 Ω
   H3-1 (D) - H8-1 (D)	Always	Below 1 Ω
   H3-4 (U) or H8-2 (U) - Body ground	Always	10 kΩ or higher
   H3-1 (D) or H8-1 (D) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Result: 

OK 

See step  4

1. Remove the power window regulator master switch assembly.

   Refer to REMOVAL [08/2016 - ]

2. Inspect the power window regulator master switch assembly.

   Refer to INSPECTION [08/2016 - ]

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPLACE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY. Refer to  REMOVAL [08/2016 - ] 

Result: 

OK 

See step  5

1. Measure the resistance according to the value(s) in the table below.

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   I4-16 (U) - H3-5 (SU)	Always	Below 1 Ω
   I4-15 (D) - H3-2 (SD)	Always	Below 1 Ω
   I4-16 (U) or H3-5 (SU) - Body ground	Always	10 kΩ or higher
   I4-15 (D) or H3-2 (SD) - Body ground	Always	10 kΩ or higher

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR FRONT PASSENGER DOOR). Refer to  REMOVAL [08/2016 - ] 

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR