Power Windows do not Operate Using All Window Switch [08/2016 - ]: Procedure

1. Disconnect the I4 power window regulator master switch assembly connector.
2. Measure the voltage and resistance according to the value(s) in the table below.

   Standard Voltage

   Tester Connection	Condition	Specified Condition
   I4-6 (B) - Body ground	Ignition switch ON	11 to 14 V

   Standard Resistance

   Tester Connection	Condition	Specified Condition
   I4-1 (E) - Body ground	Always	Below 1 Ω

   Result

   Proceed to
   OK
   NG

Result: 

NG 

REPAIR OR REPLACE HARNESS OR CONNECTOR 

Result: 

OK 

See step  2

1. Replace the power window regulator master switch assembly.

   Refer to REMOVAL [08/2016 - ]

   Result

   Proceed to
   NEXT

NEXT 

See step  3

1. Check the operation of the power windows by using the power window regulator master switch assembly, power window regulator switch assembly and rear power window regulator switch assemblies (for LH door or RH door).

   Refer to OPERATION CHECK [08/2016 - ]

   OK

   All power windows operate normally.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

END (POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WAS DEFECTIVE) 

Result: 

NG 

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU). Refer to  REMOVAL [08/2016 - ]