DTC C1A4B: Stop Light Relay Circuit [08/2016 - ]: Description

The skid control ECU (brake actuator assembly) sends a stop light operation request signal to the stop light relay. If the skid control ECU (brake actuator assembly) detects a malfunction in the stop light relay circuit, the pre-collision city sensor assembly stores DTC C1A4B.

DTC No.	Detection Item	DTC Detection Condition	Trouble Area
C1A4B	Stop Light Relay Circuit	Both of the following conditions are met: All of the following conditions are met: 3 seconds have elapsed since the ignition switch was turned to ON. The battery voltage is 10 V or more for 3 seconds or more. All of the following conditions are met for 1 second or more: Communication between the pre-collision city sensor and skid control ECU (brake actuator assembly) is normal. The pre-collision city sensor receives a stop light relay circuit malfunction signal from the skid control ECU (brake actuator assembly) HINT: The skid control ECU (brake actuator assembly) will detect a stop light relay circuit malfunction if any of the following conditions are met: When the voltage at the IG1 terminal is between 11 V and 14 V and the stop light illumination output (STPO) signal is on, a signal has not been input to the STP terminal continuously for 0.3 seconds or more. When the voltage at the IG1 terminal is between 11 V and 14 V and the stop light illumination output (STPO) signal is off, the input signals at the STP terminal and STP2 terminal differ continuously for 0.3 seconds or more.	Skid control ECU (Brake actuator assembly) Stop light relay Rear combination light socket and wire sub-assembly LH Rear combination light socket and wire sub-assembly RH Center stop light assembly Harness or connector

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C1A4B

Stop Light Relay Circuit

Both of the following conditions are met:

All of the following conditions are met:
- 3 seconds have elapsed since the ignition switch was turned to ON.
- The battery voltage is 10 V or more for 3 seconds or more.
All of the following conditions are met for 1 second or more:
- Communication between the pre-collision city sensor and skid control ECU (brake actuator assembly) is normal.
- The pre-collision city sensor receives a stop light relay circuit malfunction signal from the skid control ECU (brake actuator assembly)

HINT:
The skid control ECU (brake actuator assembly) will detect a stop light relay circuit malfunction if any of the following conditions are met:

When the voltage at the IG1 terminal is between 11 V and 14 V and the stop light illumination output (STPO) signal is on, a signal has not been input to the STP terminal continuously for 0.3 seconds or more.
When the voltage at the IG1 terminal is between 11 V and 14 V and the stop light illumination output (STPO) signal is off, the input signals at the STP terminal and STP2 terminal differ continuously for 0.3 seconds or more.

Skid control ECU (Brake actuator assembly)
Stop light relay
Rear combination light socket and wire sub-assembly LH
Rear combination light socket and wire sub-assembly RH
Center stop light assembly
Harness or connector