DTC C1AC1: Master Module Horizontal Axis Misalignment [12/2013 - 11/2016]: Procedure

1. Check the installation condition of the blind spot monitor sensor LH.

   Refer to OPERATION CHECK [12/2013 - 11/2016]

   HINT: 

   Take the appropriate action in accordance with the result.

   Result

   Proceed to
   NEXT

Result:  1

NEXT 

See step  2

1. Install the rear bumper.

   Refer to INSTALLATION [12/2013 - ]

2. Perform Blind Spot Monitor Beam Axis Confirmation using the Techstream.

   Refer to OPERATION CHECK [12/2013 - 11/2016]

   Result

   Proceed to
   OK
   NG

Result:  1

OK 

END 

Result:  2

NG 

REPLACE BLIND SPOT MONITOR SENSOR LH. Refer to  REMOVAL [12/2013 - 11/2016]