How To Proceed With Troubleshooting [08/2015 - ]: Procedure

Result

Result: 

NEXT 

See step  2

Standard voltage

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery before proceeding.

Result

Result: 

NEXT 

See step  3

1. Confirm customer problem symptoms.

   See HOW TO PROCEED WITH TROUBLESHOOTING [08/2015 - 08/2017] See HOW TO PROCEED WITH TROUBLESHOOTING [08/2017 - ]

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  4

1. Check for DTCs and note any codes that are output.

   See DTC CHECK / CLEAR [08/2015 - ] 

2. Clear the DTCs.

   See DTC CHECK / CLEAR [08/2015 - ] 

3. Recheck for DTCs.

   See DTC CHECK / CLEAR [08/2015 - ] 

   Based on the DTCs output above, try to force output of the same CAN communication system DTC or occupant classification system DTC by simulating the symptoms indicated by the DTC.

   Result

   Result	Proceed to
   DTC is not output	A
   CAN communication system DTC is output	B
   Occupant classification system DTC is output	C

Result: 

B 

GO TO DIAGNOSTIC TROUBLE CODE CHART. See  PRECAUTION [08/2015 - ] 

Result: 

C 

GO TO DIAGNOSTIC TROUBLE CODE CHART. See  DIAGNOSTIC TROUBLE CODE CHART [08/2015 - ]  

Result: 

A 

See step  5

1. See the Problem Symptoms Table.

   See PROBLEM SYMPTOMS TABLE [08/2015 - ] 

   Result

   Result	Proceed to
   Fault is not listed in problem symptoms table	A
   Fault is listed in problem symptoms table	B

Result: 

B 

See step  6

Result: 

A 

See step  6

1. Terminals of ECU

   See TERMINALS OF ECU [08/2015 - ] 

2. Data List / Active Test

   See DATA LIST / ACTIVE TEST [08/2015 - ] 

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  7

Result

Result: 

NEXT 

See step  8

Result

Result: 

NEXT 

END