Additional Key cannot be Registered [06/2015 - ]: Procedure

1. Check for DTCs.

   Body Electrical > Smart Key > Trouble Codes 

   NOTE:

   If a malfunction occurs, do not remove/install the vehicle auxiliary battery before checking for DTCs.

   OK

   DTCs are not output.

   Result

   Proceed to
   OK
   NG

Result: 

NG 

GO TO DIAGNOSTIC TROUBLE CODE CHART. Refer to  DIAGNOSTIC TROUBLE CODE CHART [06/2015 - ] 

Result: 

OK 

See step  2

1. Connect the Techstream to the DLC3.
2. Turn the power switch on (IG)
3. Turn the Techstream on.
4. Enter the following menus: Body Electrical / Smart Key / Data List.
5. Read the Data List according to the display on the Techstream.

   Body Electrical > Smart Key > Data List 

   Tester Display	Measurement Item	Range	Normal Condition	Diagnostic Note
   Unmatched Vehicle-ID	Key No. (incorrect or correct)	Yes or No	Yes: Communication malfunction No: Communication normal	The vehicle ID registered in the vehicle and the vehicle ID registered in the electrical key transmitter sub-assembly are different (if a key from another vehicle is brought into the vehicle exterior detection area while the doors are locked, "Yes" is displayed for "Unmatched Vehicle-ID" in the Data List). Other potential causes: An electrical key transmitter sub-assembly from a different vehicle is being used. A communication error due to wave interference. The electrical key transmitter sub-assembly or certification ECU (smart key ECU assembly) is malfunctioning.

   Body Electrical > Smart Key > Data List 

   Tester Display
   Unmatched Vehicle-ID

   Result

   Result	Proceed to
   "No" is displayed	A
   "Yes" is displayed	B

Result: 

B 

See step  4

Result: 

A 

See step  3

1. Check that the gearshift control unlocks.

   Refer to SYSTEM DESCRIPTION [06/2015 - ]

   HINT: 

   Check that the communication between the transmission control ECU assembly and certification ECU (smart key ECU assembly) is normal.

   OK

   The gearshift control unlocks.

   Result

   Proceed to
   OK
   NG

Result: 

NG 

GO TO ELECTRONIC SHIFT LEVER SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [06/2015 - ] 

Result: 

OK 

See step  4

1. Using other unregistered electrical key transmitter sub-assemblies, perform the additional registration procedure.

   OK

   Additional registration can be completed.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

REPLACE ELECTRICAL KEY TRANSMITTER SUB-ASSEMBLY (FIRST REGISTERED KEY WAS DEFECTIVE). Refer to  REGISTRATION [06/2015 - ] 

Result: 

NG 

See step  5

1. Temporarily replace the certification ECU (smart key ECU assembly) with a new one and register the electrical key transmitter sub-assemblies to the new ECU.

   HINT: 

   • For replacement.

     Refer to REMOVAL [06/2015 - 11/2018] , or refer to REMOVAL [11/2018 - ]

   • For registration.

     Refer to REGISTRATION [06/2015 - ]

   OK

   The key ID can be registered.

   Result

   Proceed to
   OK
   NG

Result: 

OK 

END (CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) WAS DEFECTIVE) 

Result: 

NG 

GO TO OTHER PROBLEM (New key cannot be Registered). Refer to  New Key cannot be Registered [06/2015 - ]