DTC C1AC2: Slave Module Horizontal Axis Misalignment [06/2015 - ]: Procedure

1. Check the installation condition of the blind spot monitor sensor LH.

   Refer to OPERATION CHECK [06/2015 - ]

   HINT: 

   Take the appropriate action in accordance with the result.

   Result

   Proceed to
   NEXT

Result: 

NEXT 

See step  2

1. Install the rear bumper.

   Refer to INSTALLATION [06/2015 - 11/2018] , or refer to INSTALLATION [11/2018 - ]

2. Perform Blind Spot Monitor Beam Axis Confirmation using the Techstream.

   Refer to OPERATION CHECK [06/2015 - ]

   Body Electrical > Blind Spot Monitor Slave > Utility 

   Tester Display
   BSM Slave Beam Axis Adjustment

   Body Electrical > Blind Spot Monitor Slave > Utility 

   Tester Display
   BSM Slave Beam Axis Display

   Result

   Proceed to
   OK
   NG

Result: 

OK 

END 

Result: 

NG 

REPLACE BLIND SPOT MONITOR SENSOR LH. Refer to  REMOVAL [06/2015 - ]