LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2017 >> Mirai >> Repair and Diagnosis (Single Page) >> Restraints >> Seat Belts >> Pre-Collision System - Diagnostic Codes & Circuit Tests >> Pre-Collision System >> DTC U0300-51: Internal Control Module Software Incompatibility Not Programmed; DTC U0300-57: Internal Control Module Software Incompatibility Invalid / Incompatible Software Component [11/2018 - ] >> Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC U0300-51: Internal Control Module Software Incompatibility Not Programmed; DTC U0300-57: Internal Control Module Software Incompatibility Invalid / Incompatible Software Component [11/2018 - ]: Procedure

  1. CHECK FOR DTCs 
    1. Using the Techstream, check for EV control system DTCs.

      Powertrain > Hybrid Control > Trouble Codes 

      Result

      Result Proceed to
      EV control system DTCs are not output A
      EV control system DTCs are output B

    Result: 

    GO TO HYBRID CONTROL SYSTEM. Refer to  HOW TO PROCEED WITH TROUBLESHOOTING [06/2015 - ] 

    Result: 

    See step  2

  2. CHECK FOR DTCs (HEALTH CHECK) 
    1. Connect the Techstream to the DLC3.
    2. Turn the power switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: System Select / Health Check.
    5. Check DTCs.
    6. Turn the power switch off.

      OK

      DTCs indicating a vehicle information mismatch with the EV control ECU are not output by any ECU other than the forward recognition camera.

      Result

      Proceed to
      OK
      NG

    Result: 

    NG 

    REPLACE EV CONTROL ECU. Refer to  REMOVAL [11/2018 - ] 

    Result: 

    OK 

    See step  3

  3. READ VALUE USING TECHSTREAM 
    1. Connect the Techstream to the DLC3.
    2. Turn the power switch on (IG).
    3. Turn the Techstream on.
    4. Enter the following menus: Body Electrical / Pre-Collision System / Data List.
    5. Read the Data List according to the display on the Techstream.

      Body Electrical > Pre-Collision System > Data List 

      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      Vehicle Information (Conv/EV) Vehicle information (Conv/EV) Unknown / Conv / EV Unknown: Vehicle information not confirmed
      Conv: Conventional
      EV: Electric vehicle
      -

      Body Electrical > Pre-Collision System > Data List 

      Tester Display
      Vehicle Information (Conv/EV)

      HINT: 

      • If the vehicle information stored in the forward recognition camera is different than the actual vehicle specifications, the vehicle information stored in the forward recognition camera may be incorrect. Check for DTCs and replace the forward recognition camera if necessary.
      • If the vehicle information stored in the forward recognition camera matches the actual vehicle specifications, the installed EV control ECU is incompatible. Replace the EV control ECU with a correct one.

      Result

      Result Proceed to
      Vehicle information stored in forward recognition camera and actual vehicle specifications do not match A
      "Unknown" is displayed
      Vehicle information stored in forward recognition camera and actual vehicle specifications match B

    Result: 

    REPLACE FORWARD RECOGNITION CAMERA. Refer to  REMOVAL [11/2018 - ] 

    Result: 

    REPLACE EV CONTROL ECU. Refer to  REMOVAL [11/2018 - ]