LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2017 >> Mirai >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Smart Key System (For Start Function) - Diagnostics - Introduction >> SMART KEY SYSTEM (for Start Function) >> Precaution [06/2015 - ] >> Precaution [06/2015 - ]
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Precaution [06/2015 - ]

  1. CAUTION REGARDING INTERFERENCE WITH ELECTRONIC DEVICES 
    WARNING:
    • People with implantable cardiac pacemakers, cardiac resynchronization therapy-pacemakers or implantable cardioverter defibrillators should maintain a reasonable distance between themselves and the smart key system antennas. The radio waves may affect the operation of such devices. If necessary, the entry function can be disabled. Ask your dealer for details, such as the frequency of radio waves and timing of the emitted radio waves. Then, consult your doctor to see if you should disable the entry function.
    • User of any electrical medical device other than implantable cardiac pacemakers, cardiac resynchronization therapy-pacemakers or implantable cardioverter defibrillators should consult the manufacturer of the device for information about its operation under the influence of radio waves. Radio waves could have unexpected effects on the operation of such medical devices.
    • Ask your dealer for details for disabling the entry function.

      Refer to CUSTOMIZE PARAMETERS [06/2015 - ] 

  2. PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL 
    NOTE:
    • After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

      Refer to PRECAUTION [06/2015 - ]

    • When disconnecting the cable from the negative (-) auxiliary battery terminal while performing repairs, some systems need to be initialized after the cable is reconnected.

      Refer to INITIALIZATION [06/2015 - 11/2018] , or refer to INITIALIZATION [11/2018 - ]

  3. PRECAUTION WHEN USING TECHSTREAM 
    1. When using the Techstream with the power switch off, connect the Techstream to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the Techstream and the vehicle begins. Then select the vehicle type under manual mode and enter the following menus: Body Electrical / Smart Key. While using the Techstream, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the Techstream and the vehicle.
  4. PRECAUTION FOR REGISTRATION 
    1. If replacing any of the following parts, refer to the registration procedures.
      1. Certification ECU (smart key ECU assembly)
      2. Transmission control ECU Assembly
      3. Electrical key transmitter sub-assembly
      4. ID code box (immobiliser code ECU)
      5. Main body ECU (multiplex network body ECU)
      6. EV control ECU